Tuning Digital Television Stations; Tuning Analogue Television Stations - Grundig Vision 4 26-4931 T Manual

SPECIAL­SETTINGS
Tuning­digital­television­stations
This search deletes all television stations in-
cluded in the channel list!
Tuning­all­digital­television­stations­
with­cable­connection­by­auto­tun-
ing
1 Open the menu with »İ«.
– The »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
– +
» « or » «.
CHANNEL SETUP
Autotuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module
Active Antenna Power
Select
3 Select »Auto Tuning« with »
confirm with »●«.
4 Select »Country Selection« by pressing »
or » « and press »
Λ
setting.
5 Select the »Scan Type« with »
– +
» « or » « to select the »DTV«.
– T he »Searching...« menu appears, and the
search for digital TV stations begins. This
may take several minutes depending on the
number of television stations received.
– The search is ended when the »Programme
Table« appears.
Note:
You can stop the search by pressing »
7
İ
6 Press »
« to end the setting.
­-----------------------------------------------------------------------------------------------------
s
s
s
s
Removed
On
Back
Z
Exit
« or » « and
V Λ
V
– +
« or » « to make the
« and press
V
İ
«.
Tuning­analogue­television­sta-
tions
This setting is only necessary if you cannot re-
ceive any digital stations and you have not car-
ried out an analogue search during initial setup.
The television station can be set directly or using
the search.
Switching­the­television­to­ana-
logue­channels
1 Open the »INPUT SOURCE« menu by press-
ing »AV«.
2 Select input source »ATV« with »
and press »●« to confirm.
Note:
Additional operations are explained in the
7
following sections.
Re-tuning­all­analogue­television­
channels
These settings are only necessary if you can not
receive any digital stations or if you want to re-
tune all analogue channels.
The analogue television stations are listed in the
channel list after the digital television stations.
Note:
Plug the rooftop antenna cable (for ana-
«
7
logue television stations) into the »ANT­IN«
socket on the television.
1 Open the menu with »İ«.
– T he »PICTURE« menu appears.
2 Select the »CHANNEL SETUP« menu with
– +
» « or » «.
3 Select »Autotuning« with »
confirm with »●«.
4 Select »Country Selection« by pressing »
or » « and press »
Λ
setting.
5 Select the »Scan Type« with »
–
Press » « or »
and start the search with »●«.
« or »
V
« or »
V Λ
– +
« or » « to make the
«.
V
+
« to select the »ATV« display
ENGLISH
«
Λ
« and
«
V
27­