Advertisement
OPERATION - Dome Light/Remote Control
REMOTE CONTROL
Power
Press this button to turn Main Power to the TMX-R680A
ON or OFF (Ignition/ACC must be ON and the LCD
Panel must be open). Closing the LCD Panel turns Main
Power OFF automatically.
NOTE:
Once power has been turned OFF, the Power button must
be pressed to turn it back ON.
Dome Light
Press to turn the Dome Light ON or OFF. If the Dome
Light trigger wires have been connected to a switch, the
button operates in the following manner:
SWITCH POSITION
1) OFF - Dome light remains OFF at all times, even
when the Dome Light button is been pressed. The
Dome light will remain OFF until the switch is
turned OFF.
2) ON - The Dome light remains ON at all times,
even when the Dome Light button is pressed. To
turn the light OFF, this Switch must be OFF. The
remote, DOOR or OFF triggers will then turn the
Dome light OFF.
3) DOOR - The Dome light will turn ON and OFF
whenever the vehicle's doors are open or closed
respectively. Pressing the DOME button toggles the
Dome light ON or OFF depending upon its present
state.
Setup
Press the Setup button to make adjustments to the picture.
The various options will rotate in the following order:
(Blank) —> CONTRAST —> BRIGHTNESS —> COLOR —> TINT
Once the parameter you want to change is on the screen,
use the Volume UP or DN buttons to increase or decrease
the level respectively. If no action is taken within 5
seconds after making the selection or adjustment, the
Setup mode is ended and the OSD turns OFF. Also, by
using the Setup button to cycle past TINT, you can end
the Setup mode after TINT (Blank) as shown above.
7
Advertisement
