Advertisement
Quick Links
Advertisement
Related Manuals for Alpine TMX-R680A
Summary of Contents for Alpine TMX-R680A
- Page 1 ® TMX-R680A Mobile Overhead Monitor OWNER’S MANUAL...
- Page 3 WARNING Caution • Read this manual thoroughly before starting installation and operation. You will find a number of Safety Warnings in this manual to tell you about things that could hurt you or other people if you were to ignore the Warnings. We cannot be responsible for problems resulting from failure to observe the Warnings in this manual.
- Page 4 A/V sources (such as a VCR, DVD, TV Tuner and Video Game). The TMX-R680A combines all these features into a single pod mounted to the vehicles head liner. Alpine’s SmartView™ swivel mechanism was designed to give the rear seat passengers flexibility in adjusting the monitor for the best picture possible from any angle.
- Page 5 IR Sensor/Logo There is an IR Sensor that receives the Remote Control commands at the front of the housing. At this same location is a back-lit Alpine logo which acts as the main power indicator. Headphone Outputs (2)
- Page 6 The door will now control the Dome Light. • Delayed Dome Light If the user would like to have a delayed Dome Light in his/her vehicle, the TMX-R680A can be programmed for this feature. Please see page 12.
-
Page 7: Remote Control
OPERATION - Dome Light/Remote Control REMOTE CONTROL Power Press this button to turn Main Power to the TMX-R680A ON or OFF (Ignition/ACC must be ON and the LCD Panel must be open). Closing the LCD Panel turns Main Power OFF automatically. -
Page 8: Operation - Remote Control
OPERATION - Remote Control REMOTE CONTROL (continued) Source Press the Source button to toggle between the two A/V sources (AV1 and AV2). As you toggle, the source will be displayed on the OSD (On Screen Display). NOTE: In addition to the Remote Control Source button, each A/V input has its own wired select trigger. - Page 9 AUX Output, Audio (Right) AUX Output, Audio (Left) An Auxiliary A/V output is provided to drive an external monitor. This signal mirrors what’s being shown on the TMX-R680A display. The volume function does not affect the Auxiliary A/V Output. 5m Mini-DIN Extension Cable...
- Page 10 AV RCA Connector (Video, Audio R, Audio L) These RCA-type connectors connect to any video source. This connector is used as an A/V input for the TMX-R680A, however it may also be used as an output for other units. IGN/ACC (Red) This wire connects to the ignition or accessory line of the vehicle.
- Page 11 NOTE : Vehicle Door polarity depends on the vehicle type can be changed by the jumper SW where is located on the left side PCB in the overhead monitor. (Default: Negative Switched System) Right Side View Dome Light Rocker switch is located on Alpine overhead console...
- Page 12 WIRING/CONNECTIONS Remote Turn ON Connecting to the IGN/ACC line for other ALPINE unit or other device such as a small amplifier to turn them ON synchronizing with the TMX-R680A power ON. It gives +12V when the power is ON. This is a common Ground for the main unit and the Dome light. Another GND line connects to Pin #2 of the external dome light SW.
-
Page 13: Specifications
SPECIFICATIONS Specifications Video Display System ... NTSC (PAL available) Display Screen ... Size Back Light ... Cold Cathode Fluorescent Lamp Power Requirement ... 14.4 VDC (11 – 15 VDC alloable) Headphone Output ... 32ohm 100mW(max) Video Input (DIN) ... 1.0V p-p 75ohm Audio Input (DIN) ... - Page 14 Typical Rear Seat Entertainment System It is dangerous and illegal for the driver to watch the TV/Video while WARNING driving the vehicle. The driver may be distracted from looking ahead and an accident could occur.
- Page 16 ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD. 6-8 Fiveways Boulevarde Keysborough Victoria 3173, 98, Rue De La Belle Etoile, Z.I. Paris Nord II B.P.50016 ALPINE ELECTRONICS, INC. Tokyo office; 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel.: (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC.