Battery Installation - HoMedics JUMBO DISPLAY Manual

IEC/EN 60601-1-2
Medical electrical equipment- Part 2: Collateral standard: Electromagnetic compatibility
- Requirements and tests
IEC/EN 60601-1-11
Medical electrical equipment - Part 1-11: General requirements for basic safety and
essential performance - Collateral standard: Requirements for medical electrical
equipment and medical electrical systems used in the home healthcare environment

BATTERY INSTALLATION

Low battery warning
When the batteries get weak, the battery warning symbol appears
possible to measure temperature. The batteries must be replaced.
When the battery symbol flashes
display, the batteries must be replaced. If the batteries are too
flat, then the thermometer will switch off automatically.
NOTE:
• It is recommended to remove the batteries if the unit will not be used for an extended
period of time.
• Please store batteries away from small children and heat.
• Do not use rechargeable batteries.
• Dispose of used batteries in accordance with the applicable legal regulations.
Never dispose of batteries in the normal household waste.
Replacing the Battery
1. Use a Phillips head screwdriver to loosen
battery cover screw. Remove the battery
cover.
2. Remove used battery.
3. Replace with a lithium 3V CR2032 battery in
designated area. The + sign on the battery
should be facing upwards.
4. Place the battery cover on the thermometer
and tighten the screw to secure it in place.
and Lo appears in the
GB | 8
. It is still