Setting Items; Common Operations - Canon CR-N500 Settings Manual

Setting Items

The system setting items are summarized as follows:
Category
Video and audio HDMI/SDI
IP Streaming Video
Audio
Server HTTP/Video
RTP
Communication Network
Wireless LAN
External Connection (IP)
External Connection
(serial)
Security Certificate Management
SSL/TLS
User Management
Host Access Restrictions
System Camera
Date and Time
Environment
Language
Maintenance General
Backup/Restore
Update Firmware
Log

Common Operations

Describes common operations in system settings.
Note
If a setting that does not display a dialog in a web browser is enabled, it may not be possible to operate the Settings Page. In this case,
close and restart the web browser.

Applying Configuration Changes
When a setting is changed on the Settings Page, the [Apply] and [Clear] buttons in the upper right of the Settings
Page are no longer grayed out and can be clicked.
In this situation, if [Apply] is clicked, the changed settings will be applied.
Click [Clear] to revert to the previous settings.
Item
Setting the common output signal method for HDMI/SDI and 3G-SDI
mapping (P. 44)
General settings of the video, such as video size and quality sent
from the camera (P. 45)
Setting the bit rate for audio input from a microphone connected to
the camera or IP audio streaming (P. 47)
Setting the HTTP Server and video server (P. 49)
Communication setting using RTP Server (P. 50)
Setting the network to which the camera is connected (P. 52).
Setting the access point or IPv4 settings (P. 55) for direct connection
of the camera and Wireless LAN enabled device.
Setting the communication protocol for IP connection of the camera
with external devices such as controllers (P. 57).
Settings for serial connection of the camera (P. 59)
Settings for certificate creation and management (P. 61).
Encrypted communications and server certificate settings (P. 62).
Add/delete and set operating privileges for administrator account
information and authorized users (P. 63).
Setting separate access controls for access from IPv4 and IPv6
addresses (P. 65).
Camera Name and camera Installation Conditions, Tally Lamp, IR
remote controller, and Genlock settings (P. 67).
Camera date and time settings (P. 69).
Frame frequency settings (P. 71).
Display language settings (P. 72).
Device information and settings, license verification, reboot and
initialization settings (P. 73).
Perform backup and restoration (P. 75).
Perform firmware update (P. 76).
Log display and downloading message (P. 77).
42
Description