Metering/Unity Gain method
This method gives you more headroom than the peak method,
while maintaining a low noise floor which will be well below the
noise of most PA or live recording environments.
1. With the mic or line level signal flowing through the channel,
set the TRIM to minimum.
2. Set the CHANNEL FADER to 0 (about 2/3 up). Set all other
channel faders to minimum (off).
3. Set the MASTER fader to 0 dB (all the way up).
4. Observe the Studio 12R's LED Meter. Adjust the [TRIM]knob
until the average signal level on the meter is about 0 dB (highest
green LED), or peaks do not exceed the +10 dB LED (or whatever
maximum your system is designed for). If you ever see the
channel's PEAK LED flash, you are within 6 dB of signal
overload. Turn down the TRIM knob until the PEAK LED stops
flashing.
Studio 12R Reference Manual
Operating Instructions
29