Footswitch Controls; Program Advance - Alesis 2 Reference Manual

The display will look like this:
GEN 1 ENV ATTACK TIME: 0.00Sec
12
PRESS [PAGE>} to advance the cursor to the next field and turn the
[VALUE/ENTER] knob to adjust the input envelope's attack time (0.00 to 10.00
seconds). This controls the rate that the envelope's control will affect the
selected target parameter once it has crossed the attack threshold.
13
Press [PAGE>] to advance to Page 9.
If the selected Input Generator's type is Input Envelope, the display will look like
this:
GEN 1 ENV RELEASE TIME:
0.00Sec
14
Press [PAGE>] to advance the cursor to the next field, and turn the
[VALUE/ENTER] knob to adjust the input envelope's release time (0.00 to 10.00
seconds). This controls the rate that the envelope's value will fall after the source
level has crossed the release threshold.

Footswitch Controls

Two footswitch jacks, [ADVANCE] and [BYPASS], are provided on the back panel of
the QuadraVerb 2.

Program Advance

The [ADVANCE] jack allows the QuadraVerb 2's Programs to be advanced remotely
from a footswitch. The Program numbers included can be selected by setting the
Footswitch Range, found on Global Page 2. The range can be as small or large as you
like, including either the Preset or User banks or both. Example: If the Footswitch
Range is from Preset 89 to User 14, the Programs will continuously cycle from Preset
89 to User 14 whenever the Advance footswitch is triggered.
To set the Footswitch Range:
¿
Press [GLOBAL].
The [GLOBAL] button's LED will light.
¡
Press [PAGE >] to advance to Global Page 2.
The display will look like this:
FOOTSWITCH: 00 Pset TO 00 Pset
¬
Turn the [VALUE/ENTER] knob to select the Program number to be the
beginning point of the Footswitch Range (Preset 00–99 or User 00–99).
÷
Press [PAGE >] to advance the cursor to the next field, and use the
[VALUE/ENTER] knob to select the Program number that is to be the end point
of the Footswitch Range.
When the last Program of the Footswitch Range is reached and the Advance
footswitch is pressed again, the first Program in the Footswitch Range will once again
be selected.
QuadraVerb 2 Reference Manual
Advanced Applications - Chapter 6
85