Alesis 2 Reference Manual page 66

MIDI CHANNEL: 1
Page 2: MIDI Program Change. This determine whether or not the QuadraVerb
2 will respond to incoming MIDI program change messages. This can be set to either
"ON" (recognize), "OFF" (ignore) or "TABLE" (use Program Table). When turned on,
the QuadraVerb will recognize program change messages received on the same MIDI
channel it is set to receive on, and respond by calling up the equivalent Program
number from the User bank. When set to "TABLE", the Program that is recalled is
based on how the Program Table is set up (see below).
MIDI PROGRAM CHANGE: OFF
Page 3: Program Table. The Program Table allows you to intercept incoming
program change messages and have them recall specific Programs (in either the
Preset bank or the User bank) which may not be the same number value as the
program change message received. There are 128 different possible MIDI program
change messages (000 through 127). However, the QuadraVerb 2 has 200
Programs to choose from. Therefore, the Program Table allows us to choose which of
the 200 Programs will be recalled when certain program change numbers are
received. The first value indicates the MIDI program change you wish to remap (000—
127). The second value in the display indicates the Program you wish to be recalled
(00—99 Preset (Pset) and 00—99 User). You can remap each of the 128 program
change numbers, if so desired.
PROGRAM TABLE: 00 = 00 User
Page 4: MIDI Thru. This determines whether information received at the [MIDI IN]
connector should be routed to the [MIDI OUT] connector. When "ON", the [MIDI OUT]
connector "echoes" any MIDI messages it receives on the [MIDI IN] connector.
MIDI THRU: OFF
Page 5: System Exclusive Receive. This determines whether the QuadraVerb 2
will respond to any received MIDI SysEx messages. SysEx (System Exclusive) is used
to control the various parameters of the QuadraVerb 2. When "ON", the QuadraVerb 2
will respond to SysEx messages. When off, SysEx messages will be ignored.
SYSTEM EXCLUSIVE RECEIVE:
OFF
Page 6: Send MIDI Program. This page lets you dump out a single Program or
the current Program being used/edited), or the entire User bank via MIDI. The data is
sent as SysEx information. This can be sent to a MIDI storage device, or to another
QuadraVerb 2. Select either "ALL" or a Program number from 00—99 (User bank
only) or EDIT (the currently selected Program which is in the edit buffer). When ALL is
selected, simply pressing the [VALUE/ENTER] button starts the MIDI dump. The
display will read "MIDI PROGRAM DUMP IN PROGRESS..." indicating that all 100 User
Programs are being sent out the [MIDI OUT] connector. If EDIT or 00—99 is selected,
a second value appears which lets you select which Program location to send the
selected Program to. This is useful when you are connected to another QuadraVerb
2, and wish to transfer a Program from one to the other but do not want to store it in
the same location.
SEND MIDI PROGRAM: 00 TO 00
QuadraVerb 2 Reference Manual
Description of Controls - Chapter 5
65