Patching In The New Blocks - Alesis 2 Reference Manual

Chapter 4 - Making Your Own Patches
¿
Press [ROUTING].
The [ROUTING] button's LED will light.
¡
Press the [BLOCK >] button until the pointer appears above R OUT.
¬
Press [< PAGE] to advance to Routing Page 3.
The display will look like this:
DELETE ROUTE FROM: INPUT
RIGHT
÷
Turn the [VALUE/ENTER] knob until the display reads "EQ 1 MIX" and press the
[VALUE/ENTER] button.
The display will flash until the [VALUE/ENTER] button is pressed. At the same
time, the "patch cord" connecting the EQ out to the R OUT will disappear.

Patching In The New Blocks

Now its time to reroute the signal so the effects form a chain.
¿
Press [ROUTING].
The [ROUTING] button's LED will light.
¡
Press the [< BLOCK] button until the pointer appears above Block 2.
¬
Turn the [VALUE/ENTER] knob until the display looks like this:
ADD ROUTE FROM: EQ 1 MIX
÷
Press [VALUE/ENTER] to select the route.
The display will flash until the [VALUE/ENTER] button is pressed. At the same
time, the "patch cord" connecting the EQ to the Delay will appear. Also, the
display will automatically advance to Routing Page 2, where you can adjust the
level of this signal going into the Delay in Block 2. This defaults to -6.0dB, which is
the halfway point between maximum and minimum. This gives you enough
overhead so that, if later you need more gain, you can raise this signal to a higher
level.
ƒ
Press [VALUE/ENTER] to set the input level. The display will automatically return
to the "Add Route" page
ª
Press the [BLOCK >] button until the pointer appears above Block 3.
D
Turn the [VALUE/ENTER] knob until the display looks like this:
ADD ROUTE FROM: DLY 2 MIX
«
Press [VALUE/ENTER] to select the route.
The display will flash until the [VALUE/ENTER] button is pressed. At the same
time, the "patch cord" connecting the Delay to the Reverb will appear. Set the
level on page 2 as before.
52 QuadraVerb 2 Reference Manual