Fujitsu BS2000 SE Series Operating Manual page 68

Server Unit /390
----- PROGRAM LOAD FRAME: DETAIL-1 -----
-LOAD FUNCTION-
==>
*1 START AUTO
*2 START FAST
*3 START DIAL
*4 START
*5 SYSTEM DUMP
*6 LOAD CLEAR -----+
*7 LOAD NON CLEAR -+
PARMS=>
CL-0
RA
Figure 31: PROGRAM LOAD FRAME: DETAIL-1 screen
Before completing this frame, check whether the correct firmware for operating Native BS2000 or VM2000 has been
loaded by the SVP. Information on this is provided in the DETAIL-2 STATUS field.
DETAIL-2 STATUS
The settings in DETAIL-2 FRAME are displayed here.
Check the settings. If the settings are correct, complete this frame and execute the Initial Program Load by
pressing the ENTER key.
If the settings are not correct, correct them in DETAIL-2 FRAME (see below).
In our example
VM MODE: NATIVE
changed in DETAIL-2 FRAME for this example.
Swap to PROGRAM LOAD FRAME: DETAIL-2
For this example, go to the
continue there.
If the DETAIL-2 STATUS is correct, fill in the entry fields as follows:
-IPL DEVICE-
==> 2
*1 PRESET GROUP ------------------+
>*2 CURRENT GROUP --------+
*3 UNIT ADDRESS -+
|
+MT CONTROL-
==> 1
>*1 NL
*2 SL
*3 NL-REWIND
*4 SL-REWIND
CPU-0 CHP-0
, i.e. the firmware for BS2000 operation, is loaded. This setting must be
section "Setting operating mode via PROGRAM LOAD FRAME: DETAIL-2"
E90L01G
+
A108 A108
XXXX
XXXX
XXXX
--- DETAIL-2 STATUS --
VM MODE : NATIVE
EXA MODE : ENABLE
IPL EXEC : ENABLE
*ENTER EXECUTE
*PF3 GO TO BASIC FRAME
*PF9 GO TO DETAIL-2
RUN
[]-[]00
|
+
A108
XXXX
XXXX
XXXX
and
68