Ld) Program Load Frame: Detail-1 - Fujitsu BS2000 SE Series Operating Manual

Server Unit /390

4.4.2.1 (LD) PROGRAM LOAD FRAME: DETAIL-1

----- PROGRAM LOAD FRAME: DETAIL-1 ----- E90L01G
-LOAD FUNCTION-
==>
*1 START AUTO
*2 START FAST
*3 START DIAL
*4 START
*5 SYSTEM DUMP
*6 LOAD CLEAR -----+
*7 LOAD NON CLEAR -+ XXXX XXXX
PARMS=> 1
CL-0
RA
Figure 8: PROGRAM LOAD FRAME: DETAIL-1 screen
By making entries in this frame and pressing the ENTER key you can control the execution of an IPL.
Before completing this frame, check whether the correct firmware for operating Native BS2000 or VM2000 has been
loaded by the SVP. Information on this is provided in the DETAIL-2 STATUS field.
DETAIL- In this position the current settings of the PROGRAM LOAD FRAME: DETAIL-2 are displayed.
VM MODE shows the loaded firmware:
2 STATUS
NATIVE
AVM/EX
If the setting is not correct, click on PF9 to correct the entry in PROGRAM LOAD FRAME: DETAIL-2. After you
have made the correction and clicked on PF9, the setting is stored and you are returned to this frame (see
PROGRAM LOAD FRAME: DETAIL-2"
If the setting is correct, complete this frame and execute the IPL.
LOAD FUNCTION ==>
START AUTO
1
START FAST
2
START DIAL
3
-IPL DEVICE-
==> 2
*1 PRESET GROUP ------------------+
>*2 CURRENT GROUP --------+
*3 UNIT ADDRESS -+
|
+MT CONTROL-
==> 1
>*1 NL
*2 SL
*3 NL-REWIND
*4 SL-REWIND
CPU-0 CHP-0
for BS2000 operation
for VM2000
).
The following function is selected after the corresponding number has been entered:
executes IPL: automatic startup
executes IPL: fast startup
executes IPL: dialog startup
+
A108 A108
XXXX XXXX
XXXX XXXX
--- DETAIL-2 STATUS --
VM MODE : AVM/EX
EXA MODE : ENABLE
IPL EXEC : ENABLE
*ENTER EXECUTE
*PF3 GO TO BASIC FRAME
*PF9 GO TO DETAIL-2
RUN
[]-[]00
|
+
A108
"(LD)
31