Track Slip - Alesis ADAT-HD24 Reference Manual

Using the Undo command
First, perform a Copy, Cut or Paste command.
Press the button. If your last operation was a
UNDO
Paste command, the display would read:
Undo Last
Track Paste? Y /N
Press the (L) button. The display should read:
YES
Undo Track Paste
Are You Sure? Y /N
Press the (L) button. You will see a progress
YES
bar on the display, then it will read:
Complete
Paste Undo On/Off
If the Paste Undo function doesn't work, make sure
that it's turned on in the Utility menu. Press
until you reach page 9:
Util09:Undo
Paste Undo: O ff
Press (L) to enable the Paste Undo function if
YES
it's disabled, or
NO
The two reasons to turn Paste Undo OFF:
Speed. If the HD24 doesn't have to make a
•
copy of existing data before pasting new data,
paste operations will take place much faster.
Conserving disk space to copy and
•
paste larger regions. With Paste Undo
OFF, the edit buffer can be used to store all copy
data. No space needs to be "held back" to store
undo data.
CUT and COPY are always UNDO-able; they are not
disabled by Utility 9 "Paste Undo: Off"
ADAT HD24 Reference Manual
Undo
(M) to disable it.

Track Slip

The Track Slip function is similar to the Track Delay
function in tape-based ADAT recorders. Using
Track Slip, however, audio can be delayed or
advanced in time up to 170 milliseconds (0.17
seconds).
The Track Slip function can only be applied to entire
tracks at once, not to a region. Edit Start and Edit
End points do not affect this function.
Turn Track Slip off before attempting to record. Track
Slip can be used only during playback, not
during recording.
Using Track Slip
Press the
read:
UTILITY
1. Press the
selected the word OFF. Change this to ON by
pressing
This setting allows you to toggle Track Slip off
without losing the settings of your individual tracks.
2. Press the
Track Number field.
3. Press the
track you wish to Slip.
4. Press the
time field. Pressing the
buttons will change the Track Slip time in
milliseconds.
5. Press the
the Track Slip time in 1/10ths of a millisecond.
6. Press both the
simultaneously to return the Track Slip time to
000.0ms.
chapter 6 • editing
button. The display should
TRACK SLIP
Track Slip OFF
Track0 1 > 000.0ms
<
button until you have
(CURSOR LEFT)
(L).
YES
>
button to select the
(CURSOR RIGHT)
(L) or (M) buttons to select the
YES NO
Track Slip OFF
Track0 5 > 000.0ms
>
button to select the
(CURSOR RIGHT)
YES
>
button again to edit
(CURSOR RIGHT)
(L ) and
YES
( L) or
(M)
N O
(M) buttons
N O
63