Alesis ADAT-HD24 Reference Manual page 62

Pasting Audio to a Different Song
You can use the
PASTE
different song. This is often used to copy tracks
from an 8-track song into a 24-track song for more
available tracks.
You could use this technique to save a copy of a
song, so that the original stays untouched; but
in most cases copying an entire song is more
efficient using Utility 01 (because it won't use
up the edit buffer space).
To Paste tracks into a different song:
1. Cut or Copy audio from entire tracks or any
section of the song, using the procedures
described in the previous sections.
2. Press the
SONG SEL
(L) or (M) buttons to select a new song.
NO
Note that you can't paste into a song with a different
Sample Rate.
3. Press and hold the
select the tracks that you want to paste into.
When you changed songs, the selected tracks were
automatically cleared.
4. Press the
PASTE
paste the audio. The display will read:
Paste To
Edit Start?
You may check this point by pressing the audio
using the
EDIT START
Edit Start point of each Song in
the HD24 is unique.
of the source
different
destination Song.
If necessary, set a new Edit Start point using any of
the methods described on page 56, "Using the Edit
Start and Edit End Points".
OR, if you wish, you can use the procedure on the
previous page to change the display to:
Paste To
T rack Start?
ADAT HD24 Reference Manual
command to move audio to a
button, then press the
button, then
TRACK EDIT
button when you're ready to
Y /N
button. Note that the
The Edit Start
Song is probably
from that of
Y/N
5. Press the
6. Press the
The display will draw a progress bar while it's
pasting the audio, then it will read:
YES
the
chapter 6 • editing
OR
Paste To
R egion Start?Y/N
(L) button. The display will read:
YES
Track Paste
Are You Sure? Y /N
(L) button to confirm the paste.
YES
Track Paste
Complete
61