Editing Programs; Revert-To-Stored? / Unrevert-To-Edited; Add To Faves? / Remove Fave; Send To Setup - Alesis Micron Reference Manual

6
Programs

Editing Programs

1. Revert-to-Stored? / Unrevert-to-Edited?

If you have edited a program, you may revert back to the original
version. Once you are on this page, press the control knob to
revert.
Go back to your edited state by pressing the control knob a
second time to unrevert.
Use revert and unrevert often in order to compare your changes to
the original program. When you're satisfied with your work, press
[store] to save your changes.

2. Add to Faves? / Remove Fave?

Press the control knob to enter edit mode. Once you are on this
page, press it again to add this program to the faves (favorites) list.
When you make a program a fave, it is accessible not only in its
own category but also in the faves category.
To remove the program from your faves list, first select it in the
faves category (see the sidebar) and then enter edit mode by
pressing the control knob. "Remove fave?" is the first option you
will see. Press the control knob to confirm the action.

3. Send to Setup?

Pressing the control knob at this option sends you to [setups]
mode and allows you to make this program a part in the last-
selected setup.
Any existing setup already has one or more parts, so you will be
given the option of adding this program to the setup in one of the
following ways:
send to part
1.
program. The setup part's level, effects mix, key range, and latch
status are retained. See the sidebar for a description of how the
parts' letter assignments are affected.
60
. The setup's part's is replaced by the current
Accessing Faves
Press and hold the
[programs] button and press
the low D key (labeled
"faves") to access the
programs you've stored in the
faves category.
Send to setup only allows the
option of sending the
program to the current setup.
Therefore, you may need to
jump out of program editing
to choose a setup before
returning to programs and
following this procedure.