Alesis Micron Reference Manual page 49

k. Knobs
Allow any combination of the x, y, and z knobs to work on this
part. The knobs' functions are determined by the settings assigned
for this part's program within the [programs] screens.
As with controllers, you can assign a knob exclusively to the
current part by holding down the [setups] buttons and wiggling
the knob. This will enable the knob for this part and disable the
knob in all other parts.
As always, when you turn a knob, the display will indicate which
program parameter you're changing. If you have multiple parts
that respond to the same knob, the display will only show this
information for a single part, but rest assured that all of the parts
are being affected.
l. Pedals
Assign the sustain and/or expression pedal to this part. By
default, they are both assigned.
m. Split?
Split allows you to create a new part by splitting the key range of
the current part. After the split, one part will use the keys below
the split point, and the other part will use the keys above. The two
parts will otherwise be identical.
If you choose to split a part, the Micron will prompt you to select
the key on the keyboard where the split should occur. To select
the split point, turn the control knob or play a key. You can use
the [octave] buttons if your desired split point is outside of the
current key range.
The newly-created part will be assigned the next letter after the
current part's letter. All subsequent part letters will be
incremented by one.
n. Layer?
Choose layer to duplicate the current part.
The newly-created part will be assigned the next letter after the
current part's letter. All subsequent part letters will be
incremented by one.
o. Remove?
Choose remove to remove the current part. All subsequent parts
will be re-lettered accordingly.
5
Setups
Jumping between parts
To jump between parts, hold
down the [setups] button and
press a key on the right side
of the keyboard, starting with
the A above middle C.
47