Creating And Playing A Sequence - Agilent Technologies N6030A Series User Manual

Figure 2-4 N6031A and N6033A

Creating and Playing a Sequence

Follow steps 1-5 of
configure the signal path and clock reference.
1. Select the Sequencer tab.
2. From the Segment List select Add. This brings up a Segment
3. Browse and select the 100 MHz waveform, then click OK.
NOTE For dual channel sequencing, add the same waveform to both channel 1 and
channel 2. Currently, the software does not support independent channel
sequencing.
4. Repeat steps 2 and 3 twice, selecting the 2tone and 5_tone waveforms.
Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
"Generating a Single Tone Signal" on page 28
Information window.
Basic Operation
Using the Graphical User Interface
to
33