Verifying System Operation; System Set Up; Waveform Playback - Agilent Technologies N6030A Series User Manual

Verifying System Operation

System Set Up

Embedded Controller
1. Start with the controller (PC) turned off.
2. Connect the keyboard, mouse, and monitor to the controller front panel
3. Connect the power cord to the chassis and turn the power on.
MXI-4 Link
1. Start with the controller (PC) turned off.
2. Connect the cable from the PCI card in the PC to the connector on the
3. Connect the power cord to the chassis and turn the power on.
4. Turn the PC on.

Waveform Playback

NOTE
An Agilent E4440A Spectrum Analyzer or equivalent is required to view the
waveforms.
1. Connect a 10 MHz reference to the AWG front panel connector. If you
2. Connect the channel 1 positive (+) output to the spectrum analyzer RF
3. Open the user interface by double-clicking the N6030A Control Utility
NOTE If you do not have an icon, go the Start > Programs > Agilent > N6030A
and select Control Utility to open the user interface.
Chapter 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
interface.
MXI-4 card installed in the chassis.
are using a PXI chassis, use the backplane 10 MHz reference.
input connector.
icon placed on the desktop during installation.
Introducing the N6030A Series AWGs
Verifying System Operation
21