Connecting The Connecting Cables; Kma 822 (Trolley With Pc And Operator Display Unit); Setting Up Trolley; Fitting Keyboard - Bosch KMA 800 Original Instructions Manual

4.1.4

Connecting the connecting cables

¶
The connection cables should be installed and
attached with cable ties according to Chapter 4.4
"Connection cables".
4.2 KMA 822 (trolley with PC and opera-
tor display unit)
4.2.1

Setting up trolley

1
2
Fig. 9: Trolley with PC, monitor and printer
¶
Set up the trolley (fig. 9, item 2) next to the injection-
pump test bench.
Robert Bosch GmbH
Initial Commissioning | KMA 802/822 | 29
4.2.2

Fitting keyboard

i
For ideal ease of use, the keyboard should be posi-
tioned at a distance of 40mm from the rear edge of
the flap.
1. Attach the keyboard (fig. 9, item 3) to the trolley flap
with a burr fastener.
2. Route keyboard connecting cable through cable
duct.
3. Attach the keypad connecting cable to the intermediate
panel with a cable tie (strain relief). When doing so,
make sure the length of the keypad connecting cable
between the keypad and connecting cable fastener is
sufficient to ensure that the keypad connecting cable is
not strained on closing the flap.
4.2.3

Fitting the PC

¶
Install the PC (fig. 9, item 5) in the trolley (fig. 9,
item 2). Remove the bottom rear wall for this purpo-
se. Install PC (fig. 9, item 5) into the bottom com-
3
partment from behind.
4.2.4 Connecting the connecting cables
¶
Install the connecting cables as described in
Chapter 4.4 Connecting cables, and secure them to
the rear of the trolley with cable ties. Then re-attach
4
the bottom rear wall to the trolley.
5
en
|
1 689 979 674 2013-12-23