Configuration Basics; Configuring On The Bench - Emerson Rosemount 2088 Reference Manual

Reference Manual
00809-0100-4108, Rev BA
Table 2-1. Rosemount 2088 device revisions and files
NAMUR
Software software
release date revision
1.0.0
January 2013
January 1998 N/A
(1)
(1) NAMUR Software Revision is located on the hardware tag of the device.
(2) HART Software Revision can be read using a HART capable configuration tool.
(3) Device Driver file names use Device and DD Revision, e.g. 10_01. HART Protocol is designed to enable legacy device driver revisions to continue to communicate with
new HART devices. To access new functionality, the new Device Driver must be downloaded. It is recommended to download new Device Driver files to ensure full
functionality.
(4) HART Revision 5 and 7 Selectable, Local Operator Interface, Scaled Variable, Configurable Alarms, Expanded Engineering Units.
2.4

Configuration basics

Set all transmitter hardware adjustments during commissioning to avoid exposing the
transmitter electronics to the plant environment after installation.
The Rosemount 2088 can be configured either before or after installation. Configuring the
transmitter on the bench using either a field communicator, AMS Device Manager, or Local
Operator Interface (LOI) ensures all transmitter components are in working order prior to
installation. Verify that the security switch is set in the unlock position (
with configuration. See
2.4.1

Configuring on the bench

To configure on the bench, required equipment includes a power supply, and a field
communicator, AMS Device Manager, or an LOI (option M4). Wire equipment as shown in
Figure 2-1
must be present between the transmitter and the power supply, see
for details. Connect the field communicator leads to the terminals labeled "COMM" on the
terminal block or 1-5V configuration, wire as shown in
communicator is connected to the terminals labeled VOUT/COMM.
Configuration
Identify device
HART
software
(1) (2)
revision
01
178
Figure 4-2 on page 41
below. To ensure successful HART communication, a resistance of at least 250 s
Find device driver
HART
universal Device
(3)
revision revision
7 10
5 9
5 3
for switch location.
Figure 2-1 on page
Section 2: Configuration
Review
instructions functionality
Manual
document Changes to
number software
00809-0100-4108 See footnote
for list of changes.
00809-0100-4690
) in order to proceed
"Power supply" on page 45
10. The Field
March 2014
Review
(4)
N/A
9