Warnings And Important Safety Precautions - Pentair COLOR SYNC CONTROLLER Installation Manual

2

WARNINGS AND IMPORTANT SAFETY PRECAUTIONS

Color Sync Controller Installation Guide
IMPORTANT!
Attention Installer: This manual contains important information
about the installation, operation and safe use of this product.
This information should be given to the owner and/or operator
of this equipment. When installing and using this electrical
equipment, basic safety precautions should always be followed,
including the following:
IMPORTANT SAFETY INSTRUCTIONS PERTAINING
TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS. READ AND FOLLOW ALL INSTRUCTIONS.
DANGER! RISK OF ELECTRIC SHOCK, WHICH CAN
RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation or service, ensure that all power to
the circuit supplying power to the system is disconnected/
turned off at the circuit breaker.
Grounding (earth bonding) is required. The Color Sync
Controller should be installed by a qualified professional
and grounded.
Read Safety Precautions and Important Instructions.
Before attempting any electrical wiring, be sure to read
and follow Safety Instructions. Wiring should only be
performed by a qualified professional.
Before installing this product, read and follow all warning
notices and instructions which are included. Failure to follow
safety warnings and instructions can result in severe injury,
death, or property damage. Call (800) 831-7133 for additional
free copies of these instructions.
For Installation of Electrical Controls at Equipment Pad (ON/OFF
Switches, Timers and Automation Load Center)
Install all electrical controls at equipment pad, such as on/off switches,
timers, and control systems, etc. to allow the operation (startup, shut-
down, or servicing) of any pump or filter so the user does not place
any portion of his/her body over or near the pump strainer lid, filter
lid or valve closures. This installation should allow the user enough
space to stand clear of the filter and pump during system start-up,
shut down or servicing of the system filter.