Rinnai Linear Series Flue Installation Manual page 8

Flueing options continued
Up and back, and up and over flueing
Up and back through the wall flueing for walls up to 385 mm thick. Flue can be extended if the wall
thickness is greater than 385 mm by using additional lengths of flue pipe.
1. Adaption flue - LSFKIT01
2. 45° bends - ESBEND
3. Flue pipe - ESPIPE900
4. Wall terminal - ESWTERM
Down and out flueing
The down and out flue allows for the adaption flue to face downwards, and for the flue to run
vertically through a hole in the floor, and then to terminate horizontally outside.
1. Adaption flue
2. Flue pipe
3. 45° bends
4. Wall terminal
5. Wall plate
Vertical flueing
The vertical in-wall flue installation is installed against an internal wall or
other suitable cavity, and is run vertically upwards to a vertical termination
above the roof.
8 | Linear flue installation guide 13541-A 01-20
- LSFKIT01
- ESPIPE900 x 2
- ESBEND
- ESWTERM
- ESPLATE (not shown)
1. Adaption flue
2. Flue pipe
3. Vertical terminal
1. Adaption flue - LSFKIT01
2. 45° bends - ESBEND
3. Flue pipe
- ESPIPE900 x 2
4. Wall terminal - ESWTERM
1. Adaption flue
2. Flue pipe
3. 45° bends
4. Wall terminal
5. Wall plate
- LSFKIT01
- ESPIPE900
- ESROOFCOWL
- LSFKIT01
- ESPIPE900 x 3
- ESBEND
- ESWTERM
- ESPLATE (not shown)