Panasonic PressIT TY-WPS1 Operating Instructions Manual page 33

Panasonic display link function
Just connect the receiver to a Panasonic display supporting this product using HDMI cable and turn
them on to perform the link operation. (It is necessary to set [Wireless presentation link] to [On].)
Set link function details in the following setting menus.
■
Check
Sets external device link.
[Check]- submenu screen
Check
Please check the display to register.
Wireless presentation link
●
[Please check the display to register.]
Sets whether to display or hide the information of the device connected to the HDMI terminal.
[Off]: Connected device information is not displayed.
[On]: Connected device information is displayed as shown below.
HDMI1
16:9
Player1
Note
• The obtained information of either signal or HDMICEC is displayed.
• Up to the first 16 characters obtained are displayed.
●
Wireless presentation link
Sets the link of the Display with this product.
[Off]:
Does not link with this product.
[On]: Links with this product.
Note
• When this product. is connected to the HDMI terminal, the link function works.
• The following functions are fixed.
These settings are held even if this function is switched from [On] to [Off]. The settings can be changed on each
setting menu.
• [Picture mode] is fixed to [Graphic].
• [HDMI-CEC control] is fixed to [Enable]. [Display → Device] is fixed to [Power off / on]. [Device → Display] is
fixed to [Power off / on].
• Even if this function is set to [Off], the HDMI-CEC function works.
Off
On
English 33