Panasonic PressIT TY-WPS1 Operating Instructions Manual page 31

●
Date/Time setting
●
Reboot
●
Reset to Factory Default
■
About Device
Displays [SSID], [Firmware Version], [Wireless Channel] and other basic information related to this product.
When the transmitter is connected, the basic information of the transmitter is also displayed.
■
Software licenses
Displays the software license description.
Specifies the time zone and the display style of date displayed on the standby
screen.
Time Server:
Sets the NTP saver.
When the NTP server is not specified, a server registered beforehand is
accessed.
Date and time shows the following information.
1. Information obtained from the NTP server via wireless LAN or wired LAN of
the receiver (priority)
2. Information from HDMI-CEC of the corresponding display or projector
Restart the product when the firmware is upgraded to the latest version or the
receiver does not respond.
Tap [Reboot] and select [YES].
Initializes this product to the default state. Note that the customized language
setting, resolution setting, wireless LAN setting, etc. once stored are initialized.
(SSID is not initialized.)
When the transmitter is initialized, the paired state between the receiver
and transmitter is canceled. Perform pairing according to the procedure in
"Transmitter Extension Method (Pairing)" (page 16) after initialization.
Reset RX:
Initializes the receiver only.
Reset TX:
Initializes the transmitter only.
Reset RX + TX:
Initializes both the receiver and transmitter.
English 31