Troubleshooting; Messages - Husqvarna Automower 405X Workshop Manual

8.1 Messages

The table below contains fault and information messages which can appear in the product.
There are references to menus in the product, but Autocheck can also be used in many cases.
Note: Refer to the Operator's manual for more information about how to rectify errors.
Messages
Number Message
0 No message
1 Outside working area
1582 - 001 - 23.12.2020

8 Troubleshooting

Cause
Indicates that no message is stor-
ed.
The boundary wire connections to
the charging station are crossed.
The boundary wire is too close to
the edge of the work area.
The work area slopes too much at
the boundary wire.
The boundary wire is crossed on
its way to and from an island.
The product finds it hard to distin-
guish the signal because of an in-
stallation close by.
Disturbances from magnetic ob-
jects (fences, reinforcement steel)
or buried cables close by.
Action
Check that the boundary wire is
connected correctly to the charg-
ing station.
Check that the boundary wire has
been laid according to the instruc-
tions.
Check that the boundary wire has
been laid according to the instruc-
tions.
Check that the boundary wire has
been laid according to the instruc-
tions. Refer to To examine where
to put the boundary wire in the
Operator's manual.
Put the product in the charging
station and generate a new loop
signal.
Try moving the boundary wire
and/or creating additional islands
in the work area.
Troubleshooting- 39