To Replace The Rear Bumper; To Replace The Front Bumper; To Replace The Headlights And The Charging Plates - Husqvarna Automower 405X Workshop Manual

Note: Attach a new warranty seal. The warranty seal
must be included and unbroken for the warranty to be
valid.
CAUTION: The cable routing is important to
avoid disturbance of the loop sensor board.
CAUTION: Always connect the cable to the
application circuit board before the power cable
to avoid current spikes that may harm the circuit
boards or the battery.
CAUTION: Make sure that no cables are
pinched.
CAUTION: Replace the sealing strip each time
you install the upper chassis.

6.6 To replace the rear bumper

1. Remove the body. Refer to
the body on page 19 .
2. Remove the 2 screws that hold the rear bumper to
the body.
3. Remove the rear bumper.
4. Install in the opposite sequence.
1582 - 001 - 23.12.2020
To remove and install

6.7 To replace the front bumper

1. Remove the body. Refer to
the body on page 19 .
2. Remove the 5 screws that hold the front bumper to
the body.
3. Remove the front bumper.
4. Install in opposite sequence.
6.8 To replace the headlights and the charging
plates
The headlights and the charging plates are included in
the same spare part. If the battery of the product does
not recharge this may be because of worn or damaged
charging plates. Also do a check of the contact plates on
the charging station. Refer to
plates in the charging station on page 34 .
1. Remove the top cover. Refer to
install the top cover on page 19 .
2. Remove the body. Refer to
the body on page 19 .
3. Use the maintenance tool to push the clips to
remove the headlights.
4. Remove the cable to the headlights from the cable
holders.
To remove and install
To replace the contact
To remove and
To remove and install
Repair instructions- 21