Cleaning; Servicing; Storage; Waste Disposal And Environmental Protection - Parkside PWS 125 D3 Translation Of The Original Instructions

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.

Servicing

Replacing carbon brushes
Switch off the appliance and dis-
connect the power supply. Let the
appliance cool down.
1. Loosen the screw (
nance cover (
2. Remove the maintenance cover (
3. Lift the compression spring (20) out of
the groove for the spring (22) the car-
bon brush (21).
4. Remove the contact plug (25) of the
contact shoe (24).
5. Pull out the brush (21) from the guide.
6. Insert a new carbon brush (21) into the
guide.
7. Place the connector (23) in a bow in
the groove for the compression spring
(22) past. Lead the connector (23)
through the side opening of the leader-
ship.
8. Slide the contact plug (25) on the con-
tact shoe (24).
9. Replace the compression spring (20)
on the nut of the compression spring
(22) the carbon brush (21).
7) of the mainte-
6).
10. Reattach the screw (
nance cover (
11. Repeat the procedure 1 to 10 on the
other side of the unit. The carbon bru-
shes are always in pairs to share.

Storage

• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be dry and stored
upright and should never be stacked.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electrical machines do not belong
6). with domestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implemented.
Ask our Service-Center for details.
• Defective units returned to us will be
disposed of for free.
GB IE
7) the mainte-
6)
3 9