Epson TM-m30 Technical Reference Manual page 66

Auto re-connect to iOS device (Bluetooth model)
In model, select [Bluetooth Setup] and then select [Auto Re-Connect iOS], you can select whether to
enable or disable auto reconnection to iOS devices.
• For details on the auto re-connect function, see
• You can change the settings with TM-m30 Utility and TM Utility for iOS.
Bluetooth Security Settings (Bluetooth model)
For models, select [Bluetooth Setup], and then select [Security], and you can change the
security settings.
If you change the security settings from "Middle" or "Low" to "High", or from "High" to "Middle" or
"Low", the link key (pairing information) is deleted. If the printer is already paired with a terminal,
unpair them and then pair again.
You can change the settings with TM-m30 Utility and TM Utility for iOS/Android.
Security
Low Pairing is always possible
(initial setting)
Middle Pairing is possible for one minute after printing the status sheet
High Pairing is possible for one minute after printing the status sheet
Pairing method when the security is set to Middle/High (from the printer)
When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure.
1
Load paper in the printer, and then turn it on.
• Make sure no errors have occurred and that the printer is not off-line.
• You cannot pair the printer while the network is starting up immediately after the power is turned
2
Open the roll paper cover, hold down the FEED button (two seconds), and then close
the roll paper cover.
3
A status sheet is printed, and the power LED flashes a pattern indicating that pairing
is now possible.
• Pairing is possible for one minute after printing the status sheet.
• You can enable pairing also by printing the status sheet by pressing the status sheet button.
66
Pairing Mode
on.
"Auto Reconnect Feature" on page
Pairing Method
Just Works
Just Works
Numeric Comparison/Passkey Entry
114.