Printing And Cutting Positions; Electrical Characteristics - Epson TM-m30 Technical Reference Manual

Printing and Cutting Positions

Manualcutter position
Autocutter position
Center of the print dotline
• The values above may vary slightly as a result of paper slack or variations in the paper. Take this
into account when setting the cutting position of the autocutter.
• When removing cut paper, the remaining roll paper is pulled at the uncut section and the pitch
of the next print may be reduced. When printing after cutting paper for prints with no pitch
reduction, feed the paper about 1 mm {16/406 inches} before printing. When the pre-feed
before next print function is enabled, this operation is performed automatically.
Settings" on page 47

Electrical Characteristics

Operating voltage
Current consumption
(24V, 25°C, standard print
density)
Approx. 9.5 mm {0.37"}
for the setting.
DC 24V ± 7%
Mean: Approximately 0.1 A (Standard, Wi-Fi, Bluetooth models)
Standby
Approximately 0.5 A (Onboard USB Powers Tablet model)
*: When charging at 2.1A
Mean: 1.5 A (Standard, Wi-Fi, Bluetooth models)
Operating
2.1 A (Onboard USB Powers Tablet model)
*: When charging at 2.1A
Note: When print ratio is approximately 18%
• Continuous printing for 50 lines (repeating 20H-7FH)
∗ Font A, 35 columns, ASCII character
• 5 lines feeding
• Autocutting
Appendix
Approx. 20.0 mm {0.79"}
Paper feed direction
See"Software
*
*
105