Epson TM-m30 Technical Reference Manual page 115

Auto Reconnect
Feature
Printer operations Perform the following reconnection
w h e n B l u e t o o t h i s
sequence.
disconnected
[Reconnection sequence]
1. The printer tries to connect to the iOS
device to which it was last connected.
2. When step 1 fails, the printer waits for
connections from other devices.
3. If connection is not established in step 2,
the printer tries again to connect to the iOS
device to which it last connected.
Steps 1 and 2 are repeated until a
connection is established.
Reconnecting to iOS Reconnect automatically.
device
Switch to connection Method 1:
from other device After disabling the Bluetooth feature of the connected iOS device, make connection settings
on the Bluetooth device that you want to connect.
(When the auto reconnect feature is enabled, it may take some time to connect.)
Method 2:
After disconnecting from the connected iOS device using applications with the TM Utility or
Epson ePOS SDK/ePOS-Print SDK disconnection feature, make settings on the Bluetooth
device you want to connect.
∗ In the following situations, even if the feature is enabled, the same operations are performed as when it is disabled.
- When pairing is canceled from the connected iOS device.
- When the last Bluetooth device connected was not an iOS device.
- When wireless communication settings are initialized from the printer.
∗ Disable this feature when using the printer from devices that are not running iOS. Otherwise, it may take some time to connect.
Enabled Disabled
Wait for a connection from the Bluetooth
device.
Make settings on the Bluetooth settings screen
on the iOS device.
Appendix
115