Furuno WR2120 Operator's Manual page 74

Block
Observed
Quality information
data
block
Angle
information
Observed
data
・
・
・
・
・
・
・
・
・
・
・
(*1) Only valid types are saved in the observed data block.
(*2)"YYYYMMDDhhmmss" of Clutter reference filename is stored.
(*3)
GCR(MTI): Ground Clutter Rejection by Moving Target Indicator.
SCR: Ship Clutter Rejection.
GCR(Ref): Ground Clutter Rejection by Using Clutter reference map.
Extended DOP: Anti-aliase Doppler velocity (post-process) *Now unsupported.
GCR(V): Ground Clutter Rejection by Using 0 Doppler velocity * Now unsupported.
GCR(Zdr): Ground Clutter Rejection by Using Zdr * Now unsupported.
GCR(ρhv): Ground Clutter Rejection by Using ρhv * Now unsupported.
R(Kdp)_Enable: This flag turns ON at the point where Rain is calculated using Kdp. * Now unsupported.
(*4) Derivation of the radar calibration constant.
Item
bit0: Signal shading,
bit1: Signal extinction,
bit2: Clutter reference,
bit3 ~ 5: Ground clutter quantity
(0: Less than 0.1mm,
(*1)(*3)
bit6: Pulse blind area
bit7: Sector blank
bit8: R(Kdp)_Enable
bit9: Extended DOP1
bit10: Extended DOP2
bit11: GCR(V)
bit12: GCR(Zdr)
bit13: GCR(ρhv)
bit14 ~ bit15: reserved
Sweep 1
Sweep 1
・
Sweep 1
Sweep 1
Sweep 2
Sweep 2
・
・
Sweep 2
Sweep 2
Sweep L
Sweep L
・
・
Sweep L
Sweep L
Detail
1: More than 0.1mm,
2: More than 1.0mm,
3：More than 5.0mm,
4: More than 10.0mm,
5: More than 20.0mm,
6: More than 50.0mm,
7: More than 100.0mm)
Angle Information 1
Observed data R
・
Observed data W
Observed data Quality
Angle Information 2
Observed data R
・
・
Observed data W
Observed data Quality
Angle Information L
Observed data R
・
・
Observed data W
Observed data Quality
65
S2E-17-0208_OM_WR2120_C
Size Off-
Data type
[byte] set
*
2×M
unsigned short