Furuno WR2120 Operator's Manual page 14

3) Setting
Display:
Select and confirm display settings.
Data acquisition:
Select and confirm log settings.
Radar site location:
Select and confirm antenna location settings.
Scan:
Setup scan mode pattern and details.
Units:
Setup radar indicator rotation speed.
1. Display
Note: This item is possible to change the setting even
when the radar is observing.
Display range [km]:
Setup radar range display.
Display data type:
Setup radar data output parameter.
Notice: WR2120 outputs the following data
types.
・ R [mm/h]: Intensity of rainfall
・ Zh [dBZ]: Reflectivity factor of raindrop
distribution and density
・ Zh_corr [dBZ]: Attenuation corrected Zh of the
horizontal polarity data
・ V [m/s]: Speed factor of Doppler velocity data
・ Zdr [dB]: Radar reflection factor difference
・ Zdr_corr [dB]: Corrected differential reflectivity
・ Kdp [deg]: Propagation phase difference rate
of change
・ Φdp [deg]: Differential propagation phase
・ ρhv: Co-polar correlation coefficient
・ W [m/s]: Doppler velocity spectrum width
Echo transparency [%]:
Set the echo returns transparency.
Antenna sweep line:
Turn ON or OFF sweep line indicator on screen.
Radiowave shielding area:
Select the radio wave shielding (sector blanking) area.
OFF: No sector blanking displayed.
1: Blank sector indicates with gray color
2: Blank sector indicates with transparent gray color (horizontal data only, it will not be transparent
on SRHI).
Note: Setting file (clip_RainMap.csv in param folder) is necessary. (refer next page "About
shielding area" for more information)
Radiowave extinction area:
Select the radio wave extinction (sector blanking) area.
OFF: No sector blanking displayed.
1: Blank sector indicates with gray color
2: Blank sector indicates with transparent gray color (horizontal data only, it will not be transparent
on SRHI).
S2E-17-0208_OM_WR2120_C
5