Testing And Measuring A Fiber Under Alarm; Testing A Fiber; Measuring A Fiber; Displaying Alarm Details - JDS Uniphase OTU-8000 (EOTU8000E) User Manual

Testing and measuring a fiber
under alarm

Testing a fiber

Measuring a fiber

Displaying alarm details

Major has been selected:
Only major and critical alarms will be
displayed (they appear in darker blue).
Tested Fiber has been unchecked:
Only unit and communication alarms
will be displayed.
Fig. 61 Filters area
1 Select in the alarm monitor page, the link under alarm on which you
wish to request a test.
2 Click on the tab Test and check Test.
3 Click on Submit.
The list of all saved OTDR tests is displayed.
4 Select one and click on
5 Once the test / measurement is completed, the trace is displayed.
1 Select in the alarm monitor page, the link under alarm on which you
wish to request a measurement.
2 Click on the tab Test and check Measurement.
3 Click on Submit.
The OTDR measurement configuration is displayed.
4 Click on Start to perform the measurement.
5 Once the measurement is completed, the trace is displayed.
1 In the Alarm Monitor page, select the alarm for which you want to
see a general description.
2 Go to the Alarm Detail page.
General information concerning the selected alarm is displayed.
3 Click on the View Trace link to see the trace corresponding to the
detected alarm.
User Manual 7OTU80050/01
Chapter 4 Operating the OTU-8000
Start to perform the test.
Exploitation
51