Instructions For Use; Cable Testing - JDS Uniphase TestifierPRO User Manual

Instructions for Use

Cable Testing

Note: Be sure to set up the unit for
shielded or unshielded cable in Setup
mode before performing any cable test.
To Test a Patch Cable (see caution
about cables with bad plugs above)
1) Plug one end of the patch cable into
the main unit�
2) Remove the remote unit from the
main unit by squeezing both the
top and the bottom center areas of
the remote and sliding it out of the
remote bay at the bottom of the main
unit� Plug the other end of cable into
the remote unit�
3) Press the mode button (Telco, Coax,
or Network) for the type of cable
being tested� If not already in cable
test mode, press the corresponding
mode button repeatedly until the
Cable Test menu item is displayed,
then press the SEL button to execute
cable test. The TestifierPROf
indicates a test in progress by
displaying the TEST icon� It sounds
a beep (if enabled), displays the wire
map result and a PASS icon if the
cable passes the T568A/B standard
and the configured shield criteria.
17