Table of Contents
Advertisement
31 March 1994
– Reinstallation –
1. Place the spacer [A] on the rear end of the shaft.
2. Set the rear bearing [B] on the rear frame.
3. Insert the rear end of the hot roller shaft through the rear bearing.
4. Place the gear [C] on the rear end of the shaft.
NOTE: The gear flange must face out.
5. Install the front bearing and spacer, then secure with two screws [D].
6. Set the rear side C-ring [E] on the rear shaft.
NOTE: a) Peel off 3 cm (1 inch) from both ends of the protective sheet
before installing a new hot roller.
b) Before setting the pressure springs, remove the rest of the
protective sheet.
c) Before reinstalling the pressure springs, refer to the installation
procedure in the Pressure Roller Replacement Section on page
5-78 of the A110/A111 copier service manual.
REPLACEMENT AND ADJUSTMENT
[E] [C]
[B]
[A]
41
[D]
Advertisement
Table of Contents
