Table of Contents
Advertisement
31 March 1994
6. Place new strip of 2 sided tape [F] on the lower casing surface as shown
in the illustration.
The side edge [G] of the tape must be flush with the edge [H] of the lower
casing and the lower edge [I] of the tape must be flush with the edge [J]
of the projection of the lower casing as shown in the illustration.
7. Place new strips of 2 sided seals [K] on the side seals [E] of both sides.
8. Place the new entrance seal [L] on the 2 sided tape [F] and the 2 sided
seals [K] as shown in the illustration.
NOTE: a) Lower edge [M] of the entrance seal must be aligned with the
edge [J] of the projection of the lower casing.
b) Make sure that there are no waves in the upper edge [N] of the
entrance seal.
REPLACEMENT AND ADJUSTMENT
33
Advertisement
Table of Contents
