Table of Contents
Advertisement
31 March 1994
11.5 REGISTRATION SENSOR AND ROLLER REPLACEMENT
[E]
1. Turn off the main switch.
2. Remove the following parts:
•
Front cover (See Exterior Cover Removal of the A110/A111 copier.)
•
Development unit
•
Right inner cover (See Inner Cover Removal.)
•
Cleaning unit (See Cleaning Unit Removal of the A110/A111 copier.)
•
Drum unit (See Drum Unit Removal of the A110/A111 copier.)
•
Rear cover (See Exterior Cover Removal of the A110/A111 copier.)
•
Main board
•
PTL board (See PTL Board Replacement of the A110/A111 copier.)
3. Remove the clutch bracket [A] (2 screws) and remove the 1st feed roller
spring clutch [B] while pressing down on the stopper [C] lever of the
solenoid (1 E-ring).
4. Remove the idle gear [D] (1 E-ring).
5. Remove the development lower guide plate [E] (2 screws each at front
and rear frames).
REPLACEMENT AND ADJUSTMENT
[C]
[B]
35
[A]
[D]
Advertisement
Table of Contents
