6 WHEELCHAIR OPERATION
Removing
1.
Pull the front rigging release lever (A).
2.
If desired, rotate front rigging assembly (B) outward or inward.
3.
Lift the front rigging assembly off of the mounting tube (C).
C
MyOn JR
For this procedure, refer to FIGURE 15 on page 51.
For maintenance and/or adjustment procedures, refer to Troubleshooting and Maintenance on page 58.
Installing
1.
Position the front rigging assembly (A) to the inside of the wheelchair frame.
2.
Insert footrest mounting pin (B) into mounting tube (C).
3.
Rotate the front rigging assembly towards the outside of the wheelchair until it locks into place.
Invacare® MyOn®
FIGURE 14
Installing/Removing Front Riggings - MyOn and MyOn Active
A
50
B
Part No 1167417