Table of Contents
Advertisement
Available languages
Available languages
Installing
WARNING
Make sure the detent pin and locking pins of the quick-release axle are fully released before operating the wheelchair.
The locking pins MUST be protruding past the inside of rear wheel hub for a positive lock.
Keep locking pins clean.
Invacare recommends inserting quick-release axles with the head end to the inside of the wheelchair to prevent accidental
release during contact activities.
1.
Install the quick-release axle (B) through the rear wheel (A).
2.
Install the rear wheel (A) and quick-release axle (B) into the axle bracket (C) on the wheelchair frame (D).
3.
If the locking pins are not protruding past the inside of the axle bushing or there is too much movement of the rear wheel assembly in a back
and forth position, refer to Adjusting Quick-Release Axles on page 87.
10.2 Adjusting Quick-Release Axles
For this procedure, refer to FIGURE 3 on page 88.
1.
Remove rear wheel and quick-release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 84.
2.
Depress detent pin (A) in the quick-release axle (B) and slide the quick-release axle through the rear wheel hub (C).
3.
Release detent pin to ensure that the locking pins (D) are fully released.
4.
Increase or decrease end play by adjusting the locknut (E) on the end of the quick-release axle.
WARNING
Make sure the detent pin of the quick release axle is fully released before operating the wheelchair.
Keep locking pins clean.
5.
Reinstall rear wheel onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 84.
Part No 1167417
10 REAR WHEELS/FRONT CASTERS
87
Invacare® MyOn®
Advertisement
Table of Contents
