Powering Off And Restarting; Port Selection - ATEN Master View CS-138A User Manual

Powering Off and Restarting

If it becomes necessary to Power Off one of the Master View units, before
starting it back up you must do the following:
1. Shut down all the computers that are attached to it, as well as all the stations
and all the computers that are daisy chained down from it (all the child
stations and the computers attached to them).
Note: 1) You must unplug the power cords of any PCs that are connected
to it that have the Keyboard Power On function, otherwise the
switch will still be receiving power from the computer.
2) If the unit is operating under external power, unplug the power
adapter cable.
2. Wait 10 seconds, then plug the Master View CS-138A stations back in,
starting with the last station in the chain and working back to the station you
originally shut down.
3. After the Master View's are up, power On the PCs, starting with the ones
attached to the last station in the chain and working back to the station you
originally shut down.

Port Selection

Controlling all the PCs connected up in your Master View CS-138A installation
from a single console could not be easier. Three methods are available that
provide instant access to any PC on the chain: Manual; Hotkey; and OSD.
w w Manual
Simply press the appropriate port selection switch on the Master View's
front panel. After you press the switch, the Selected LED lights to indicate
that the port is currently selected. The On Screen Display (OSD, discussed
on p. 19) automatically switches to highlight the PC that you have selected.
- 12 -