Rear Frame; Removal - Agilent Technologies E4406A VSA Series Service Manual

Assembly Replacement

Rear Frame

Rear Frame
Use ESD precautions when performing this replacement procedure.
CAUTION

Removal

1. Remove the instrument top brace. Refer to the
2. Remove the A17, A18, and A19 assemblies. Refer to the
3. Remove the A10 and the A12 assemblies. Refer to the
4. Remove the A7 assembly (if installed). Refer to the
5. Remove the A25 SCSI board. Refer to the
6. Remove the A22 processor assembly. Refer to the
7. Detach the flat flex cable from the daughter board.
8. Remove the rear dress panel, which includes the rear panel
9. Refer to
210
procedure.
A18 Reference, and A19 Synthesizer Assemblies"
procedure.
IF and A12 Analog IF Assemblies"
Assembly (Option B7C)"
removal procedure.
Assembly" removal procedure.
connector board and the External Trigger Input cable. Using the
T-10 driver, remove the 13 screws marked with (2) as shown in
Figure 4-26 on page 208.
Figure 4-27. Using a T-10 driver, remove the 11 screws (1)
that secure the rear frame to the deck. Remove the rear frame from
the deck.
removal procedure.
removal procedure.
"A25 SCSI Board"
"Top Brace" removal
"A17 RF,
removal
"A10 Digital
"A7 Baseband I/Q
"A22 Processor
Chapter 4