Navigating In The Parameter View; Edit View - Siemens SITRANS P Operating Instructions Manual

Operating
7.2 Operating the device with display
7.2.3.2

Navigating in the parameter view

Requirement
The button lock is disabled.
Disabling button lock (Page 135)
Procedure
1. Use the
To navigate faster, keep the
After the last parameter, you jump to the first parameter, and vice versa.
2. To switch to edit view, press the
3. To return to the measurement view, press the
7.2.4

Edit view

You change the parameter values in the edit view. Wizards are available for specific
parameters.
Parameter values
There are various parameter values:
● Enumerations (e.g. unit)
● Numerical values (e.g. damping)
①
②
③
Figure 7-4
For parameters with an associated unit, the parameter name and unit are displayed as
alternating values in
80
or buttons to navigate within the parameters.
Name of parameter and, if availa‐
ble, unit (alternating)
Enumeration arrows (for enumera‐
tions only)
Parameter ID
Example of edit view
①
. Example: Lower range value in mA.
or button pressed.
button.
button.
④
"EDIT" symbol (flashing)
⑤
Parameter value
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC