Canon imagePRESS C10000VP Practical Manual page 79

When Your Printouts Look Like���
Uneven glossy areas may occur in high
density images� (Type A)
Toner may splatter around the edges of
high density images� (Type A)
Problems with Printouts That Look Like the Following Images
Check the Cause and Remedy Below
Cause
The secondary voltage that transfers toner to the paper
does not match the specific characteristics of the paper�
Remedy
To improve this situation, adjust the value for <Adj�
Secondary Transfer Volt�> to match the specific
characteristics of the paper� There are two types of
problems: type A and type B� Adjust the value according
to the problem with your printout�
→ [Preferences] → [Paper Settings] → [Paper
Press
Type Management Settings] → select the type of paper
you are using that is having this problem → press
[Details/Edit] → [Change] for <Adj� Secondary Transfer
Volt�> → adjust the voltage value� For type A, adjust the
voltage value toward the plus end� For type B, adjust the
voltage value toward the minus end�
"Paper Type Management" > "Adjusting the
Secondary Transfer Voltage" in the e-Manual
imagePRESS C10000VP/C8000VP
77