Fiat 500 Owner's Handbook Manual page 153

133
REPLACING THE REAR
WINDOW WIPER BLADE
Proceed as follows:
raise cover A fig. 134 and remove
the arm from the car undoing the nut B
that fastens it to the pivot pin;
correctly position the new arm and
tighten the nut fully;
lower the cover.
134
WINDSCREEN WASHER
NOZZLES
If there is no jet, first check that there is
fluid in the reservoir (see the "Checking
fluid levels" paragraph in this chapter).
Then check that the nozzle holes are
not clogged; use a needle to unblock
them if necessary.
The screen washer jets can be oriented
by adjusting the nozzle angles.
F0S0137
135
The jets should be directed at about
1/3 of the height from the top edge of
the windscreen fig. 135.
IMPORTANT In versions with a sun
roof, make sure that the sun roof is
closed before operating the front jets.
F0S0109
REAR WINDOW WASHER
NOZZLE
The rear window washer jets are fixed.
The nozzle holder is on the rear window
fig. 136.
136
WARNING
185) Driving with worn windscreen wiper
F0S0110
blades is a serious hazard, because
visibility is reduced in bad weather
conditions.
186) If the window needs to be cleaned,
make sure the device is deactivated or the
key is on STOP.
F0S0111
151