Call Up The Camera Osd Menu - Interlogix TVB-6101 Manual

Call up the camera OSD menu

You can configure the camera settings via a TVI DVR. Select the PTZ protocol
TruVision Coax and click the menu button to call up the menu.
The TVS-C200 controller (Service Tool) does not support these TVI cameras.
When using the TVI output, the TVI cameras must be used with TVI DVRs. The higher
resolution TVI cameras may not be compatible with lower resolution TVI DVRs.
Note: The camera OSD is only available in English.
To set up the camera via the DVR:
1. Set up the camera hardware as described in the Installation Guide.
2. In Camera Settings
TruVision HD-TVI camera to TruVision-Coax.
3. In live view of the desired camera, click the PTZ Control icon on the live view toolbar
to access the PTZ control panel.
4. To call up the camera setup menu:
From the DVR, select Iris+.
5. Select the menu options:
From the DVR: To select an OSD item, click the directional buttons up/down. To
adjust the value of a selected item, click the directional buttons left/right.
6. Click Iris+ to enter the submenu or to confirm the selected item.
7. When the setup is complete, select
TruVision HD-TVI Cameras Configuration Manual
of the DVR, access the PTZ menu and set the protocol for the
Exit and click Iris+ to exit the camera OSD.
5