Table of Contents
Advertisement
Daily operation
3.1 Recommendations for daily operation
To avoid image retention
An unforeseen situations can occasionally occur for the Monitor, when the display is used pleased use a
safety control. It is strongly recommended you use more than one unit or prepare a spare unit in case there is
an emergency
Permanent burn-in may occur from the following:
•
Displaying color bar or static images repeatedly or for a long period of time.
•
Using the unit repeatedly in a high temperature/ high humidity environment.
•
Continuously displaying an image smaller than the monitor.
To reduce the risk of burn-in, it is recommended to turn off the power of the unit, and reduce the brightness
when the unit is not in use.
3.2 Navigating through the OSD menus
How to navigate through the OSD menus
Navigating through the OSD menus can be done by
Image 3–1
•
Push the Rotary Knob button to activate the OSD menu.
•
Turn the Rotary Knob to the left or right to select icons. The icon will be highlighted when selected
•
Push the Rotary Knob button to go into the another OSD menu.
•
Turn Rotary Knob left or right to select function
•
In order to exit from the OSD menu, choose the "Exit" icon. Hold the button around two or three seconds,
then it will completely exit from the menu regardless of where you are.
•
Turn the Rotray Knob button in a quick motion to the left or right, while the menu is not activated, then input
signal menu will turns up with " ✔ "mark which is the current available input signal. You can switch to
another input signal source by turning the knob slowly then select the target source by pushing the knob
16
R5912860 /13
AMM215WTD
Advertisement
Table of Contents
Troubleshooting
