Dvd Recorder Operation - Toshiba RD-KX50SU Owner's Manual

DVD recorder operation

AV record quality
HDD DVD-RAM DVD-R
You can select from 5 combined picture and sound
quality recording settings prior to actual recording.
Actual selection applied becomes the default setting for
normal recording or programmed recording.
e.g.
AV record quality
Setting 1
HDD
Manual 6.6
Custom setting
Setting Mode
1 Manual
2
3
4 Manual
5 Manual
Total recording time: 71min.
(with 4.7 GB unused)
• To make a combination of picture and sound
quality settings.
1) Press / / / buttons to select the desired
item ("Mode", "Rate", or "Audio quality").
2) Press ADJUST button to change the setting of
each item.
• To apply the combination of picture and sound
quality settings.
1) Press / / /
record on (HDD or DVD).
2) Press ADJUST button to change the setting.
You can confirm the available recording time for
the selected setting on the bottom screen.
3) Press ENTER button.
Notes
• A combination of picture and sound quality settings can be
set for the HDD and a DVD-RAM disc respectively.
• You can change the combination of picture and sound
quality settings also by displaying Quick Menu on LIBRARY
MENU or in stop mode, then selecting "AV Record Quality".
Either of the above methods updates the setting of this
recorder.
• If you set "SP" or "LP", you cannot select "L-PCM".
• Depending on the sound quality settings, the upper limit for
the picture quality setting differs.
• You can adjust the manual rate for picture quality by
0.2 Mbps from 2.0 to 9.2. (You cannot set the rate from 1.0
to 2.0.)
– – –
DVD
D/M1
L-PCM SP 4.6
Rate Audio quality
6.6 L-PCM
SP 4.6 D/M1
LP 2.2 D/M1
6.0 D/M2
3.2 D/M1
SETUP
buttons to select a media to
Picture record mode
HDD DVD-RAM DVD-R
Adjusts problems with the brightness of video signals of
TV broadcasts or other external input.
Press / buttons to select the source, and
to select the mode.
(Only use this setting when you cannot adjust the
brightness satisfactorily with the Custom picture setting in
Picture/Audio settings (
Important:
• This setting changes the video signal to record and the
recorded signal is not returned to the original state even
when this setting is changed after recording. When
duplicating from a VHS tape, if you can check the video
recording state beforehand, we recommend first playing
back for a while and checking the overall brightness
tendency, then setting an appropriate mode.
Standard:
The brightness of signals received with this recorder
and external input signals is adjusted automatically.
This is normally the setting to use.
Mode 1:
This setting is used to record the signals darker when
the screen is too bright.
Mode 2, 3, 4:
As the number rises, the signals are recorded brighter.
Use these modes to adjust the brightness.
/ buttons
Page 157) of this recorder.)
161