Configure The Settings For Scan To Smb - Canon varioPrint 115 Operation Manual

Configure the Settings for Scan to SMB

Introduction
To use the scan-to-SMB function, the system administrator must enable this function in the
Settings Editor on the PRISMAsync controller ([Configuration] -> [Connectivity]). The system
administrator must add SMB shares ([Workflow] -> [SMB shares]). The maximum number of SMB
shares is 3. A scan job will be sent to the selected SMB share.
How to Configure the Settings for Scan to SMB
The table below describes the settings that the system administrator must configure in the
Settings Editor.
Settings for scan to SMB in the Settings Editor
Setting
[Scan to file, scan to email and scan
to SMB enabled]
[Name]
[Description]
[Network destination]
[Domain name]
[User name]
[Password]
[Path]
Canon varioPRINT DP line
Description
This setting must be set to [Yes] to use the scan func-
tion.
The name of the SMB share.
The description of the SMB share.
Select [Domain] or [Workgroup].
Name of the domain.
The user name that is used to access the SMB server
when sending scan jobs.
The password that corresponds with the user name.
The directory on the SMB server to which the scan jobs
will be sent.
Configure the Settings for Scan to SMB
Chapter 11 - Carry Out Scan Jobs 245