Canon varioPrint 115 Operation Manual page 442

Setting
[Start of run detection]
Advised settings for different types of users
Setting
[Automatic drum
cleaning]
[Glue detection
interval]
[Glue detection
sensitivity]
[Resume auto-
matically after
cleaning]
[Start of run de-
tection]
How to Change the Settings for Automatic Drum Cleaning
Procedure
1.
On the control panel, touch [System] -> [Setup] -> [Advanced media settings] (under [Advanced]).
2.
Touch the [Automatic drum cleaning] button to enable the setting.
3.
If required, change the values of the settings described in the table.
4.
Touch [Apply] to confirm the changes.
Canon varioPRINT DP line
Description
You can indicate if the system checks for glue pollution before the
start of a run.
Select [On] if you want the system to check for glue pollution be-
fore the start of a run.
Possible values:
• [On]
• [Off]
Factory default value: [Off].
NOTE
It is advised that you enable [Start of run detection] only
when you often use recycled media.
Normal user
Plain paper Frequent use of
recycled media
[On] [On]
[350 sides] [350 sides]
[Normal] [Normal]
[Yes] [Yes]
[Off] [On]
Automatic Drum Cleaning
User that demands high quality
Plain paper Frequent use of
recycled media
[On] [On]
[100 sides] [100 sides]
[Very high] [Very high]
[Yes] [Yes]
[Off] [On]
Chapter 14 - Maintain the print system 441