Change The Print Quality Settings - Canon varioPrint 115 Operation Manual

Change the Print Quality Settings

Change the Print Quality Settings
Introduction
The print quality settings help you to optimize the quality of your prints. You can use the
following applications to change the print quality settings.
• Printer drivers.
• Job submission applications such as PRISMAprepare.
• The control panel of your printer.
• The Settings Editor on the PRISMAsync controller.
In the printer driver, in PRISMAprepare and on the control panel, you can change the settings per
job. In the Settings Editor, you can change the settings for all upcoming jobs.
The tables below describe both the basic and advanced print quality settings you can change
through the control panel.
Basic Settings
Basic print quality settings
Basic settings
[Brightness] (default 0)
[Contrast] (default 0)
NOTE
Each of the 35 combinations of contrast and brightness settings corresponds to a specific
transfer curve (i.e. transfer.ps file). In the Settings Editor, you can change the default settings for
contrast and brightness adjustments for jobs that do not ask for any brightness or contrast
adjustment.
Advanced Settings
Advanced print quality settings
Advanced settings
[Fattening] (default [Off])
[Minimum line width] (de-
fault [On])
178 Chapter 9 - Carry Out Print Jobs
Description
When your prints are too dark or too light, changing the bright-
ness can correct this problem.
-1 to -3 creates darker prints.
+1 to +3 creates lighter prints.
When the difference between light and dark areas of a print is not
big enough, you can change the contrast to correct this problem.
Example: When a blue text is displayed rastered, you can increase
the contrast to make the text more black and sharper.
Description
The fattening function can increase the readability of texts with
small fonts (< 6 points, 6/72 inch).
However, when you print special data such as bar codes, fattening
can make bar codes difficult to read. Therefore, you can turn the
fattening function off when you print such special data.
The minimum line width function is required to keep thin lines
visible. The lines in PS/PDF jobs always keep a minimum width of
1/600 inch.
However, when you print special data such as CAD drawings,
smaller lines may be required. Therefore, you can turn the mini-
mum line width function off. Then even thinner lines will be prin-
ted.
4
Canon varioPRINT DP line