Setting Channel Skip; Setting Video Input Skip; Labeling Input Sources - Toshiba Regza 42ZV650U Owner's Manual

Setting channel skip

To prevent certain channels from being viewed,
channel positions can be skipped.
1
From the SETUP menu, highlight TV Settings
and press T.
2
Press B or b to select Channel Options and
press T. The list of channels will appear.
Channel Options
Ch. Type
DTV
5-1
ATV
6
DTV
6-1
ATV
8
ATV
9
ATV
10
ATV
11
ATV
12
3
Press B or b to select a channel position to be
skipped and press T. A tick will appear in the
box.
To remove the tick, press T again.
Note: Skipped channels cannot be selected with
however they can still be accessed using the Channel
Number on the remote control.
38
Chapter 5: Setting up your TV

Setting video input skip

If you set a video input source to be skipped, it will
be skipped over when selecting the input by
repeatedly pressing +.
To turn on the skip:
1
Tune to the video input source to be skipped.
2
From the SETUP menu, highlight Manual
Setting and press T. The setting window will
appear.
Press B or b to select 8 (skip) and press O.
3
To turn off the skip:
1
Select the video input that is set to skip by direct
number entry or by using the B or b and then
press T.
< or ,
,
2
From the SETUP menu, highlight Manual
Setting and press T. The setting window will
appear.
Press B or b to select ( (skip off) and press O.
3
Labeling video input sources
You can label video input sources.
1
Tune to the input you want to label.
2
From the SETUP menu, highlight Manual
Setting and press T. The setting window will
appear.
3
Press c to move from the skip selection in order
to select a label, and pressB or b to put in the
desired characters and press T.
4
Repeat steps 1 through 3 for other inputs.
To save your settings, press T.
5
Note:
• Available characters are 0-9, A-Z, (, ), *, +, –, and /.
• To label an HDMI input, you need to set Enable REGZA-
LINK to Off (- page 60).
Manual Setting
Skip: On
Video 2 V C R
Manual Setting
Label: VCR
Video 2 V C R